| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: smbdirect: verify remaining_data_length respects max_fragmented_recv_size
This is inspired by the check for data_offset + data_length. |
| In the Linux kernel, the following vulnerability has been resolved:
zram: fix slot write race condition
Parallel concurrent writes to the same zram index result in leaked
zsmalloc handles. Schematically we can have something like this:
CPU0 CPU1
zram_slot_lock()
zs_free(handle)
zram_slot_lock()
zram_slot_lock()
zs_free(handle)
zram_slot_lock()
compress compress
handle = zs_malloc() handle = zs_malloc()
zram_slot_lock
zram_set_handle(handle)
zram_slot_lock
zram_slot_lock
zram_set_handle(handle)
zram_slot_lock
Either CPU0 or CPU1 zsmalloc handle will leak because zs_free() is done
too early. In fact, we need to reset zram entry right before we set its
new handle, all under the same slot lock scope. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: simple-card-utils: Don't use __free(device_node) at graph_util_parse_dai()
commit 419d1918105e ("ASoC: simple-card-utils: use __free(device_node) for
device node") uses __free(device_node) for dlc->of_node, but we need to
keep it while driver is in use.
Don't use __free(device_node) in graph_util_parse_dai(). |
| In the Linux kernel, the following vulnerability has been resolved:
i2c: rtl9300: ensure data length is within supported range
Add an explicit check for the xfer length to 'rtl9300_i2c_config_xfer'
to ensure the data length isn't within the supported range. In
particular a data length of 0 is not supported by the hardware and
causes unintended or destructive behaviour.
This limitation becomes obvious when looking at the register
documentation [1]. 4 bits are reserved for DATA_WIDTH and the value
of these 4 bits is used as N + 1, allowing a data length range of
1 <= len <= 16.
Affected by this is the SMBus Quick Operation which works with a data
length of 0. Passing 0 as the length causes an underflow of the value
due to:
(len - 1) & 0xf
and effectively specifying a transfer length of 16 via the registers.
This causes a 16-byte write operation instead of a Quick Write. For
example, on SFP modules without write-protected EEPROM this soft-bricks
them by overwriting some initial bytes.
For completeness, also add a quirk for the zero length.
[1] https://svanheule.net/realtek/longan/register/i2c_mst1_ctrl2 |
| In the Linux kernel, the following vulnerability has been resolved:
erofs: fix invalid algorithm for encoded extents
The current algorithm sanity checks do not properly apply to new
encoded extents.
Unify the algorithm check with Z_EROFS_COMPRESSION(_RUNTIME)_MAX
and ensure consistency with sbi->available_compr_algs. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7996: add missing check for rx wcid entries
Non-station wcid entries must not be passed to the rx functions.
In case of the global wcid entry, it could even lead to corruption in the wcid
array due to pointer being casted to struct mt7996_sta_link using container_of. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: fix linked list corruption
Never leave scheduled wcid entries on the temporary on-stack list |
| In the Linux kernel, the following vulnerability has been resolved:
net: dev_ioctl: take ops lock in hwtstamp lower paths
ndo hwtstamp callbacks are expected to run under the per-device ops
lock. Make the lower get/set paths consistent with the rest of ndo
invocations.
Kernel log:
WARNING: CPU: 13 PID: 51364 at ./include/net/netdev_lock.h:70 __netdev_update_features+0x4bd/0xe60
...
RIP: 0010:__netdev_update_features+0x4bd/0xe60
...
Call Trace:
<TASK>
netdev_update_features+0x1f/0x60
mlx5_hwtstamp_set+0x181/0x290 [mlx5_core]
mlx5e_hwtstamp_set+0x19/0x30 [mlx5_core]
dev_set_hwtstamp_phylib+0x9f/0x220
dev_set_hwtstamp_phylib+0x9f/0x220
dev_set_hwtstamp+0x13d/0x240
dev_ioctl+0x12f/0x4b0
sock_ioctl+0x171/0x370
__x64_sys_ioctl+0x3f7/0x900
? __sys_setsockopt+0x69/0xb0
do_syscall_64+0x6f/0x2e0
entry_SYSCALL_64_after_hwframe+0x4b/0x53
...
</TASK>
....
---[ end trace 0000000000000000 ]---
Note that the mlx5_hwtstamp_set and mlx5e_hwtstamp_set functions shown
in the trace come from an in progress patch converting the legacy ioctl
to ndo_hwtstamp_get/set and are not present in mainline. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: remove oem i2c adapter on finish
Fixes a bug where unbinding of the GPU would leave the oem i2c adapter
registered resulting in a null pointer dereference when applications try
to access the invalid device.
(cherry picked from commit 89923fb7ead4fdd37b78dd49962d9bb5892403e6) |
| In the Linux kernel, the following vulnerability has been resolved:
net: xilinx: axienet: Add error handling for RX metadata pointer retrieval
Add proper error checking for dmaengine_desc_get_metadata_ptr() which
can return an error pointer and lead to potential crashes or undefined
behaviour if the pointer retrieval fails.
Properly handle the error by unmapping DMA buffer, freeing the skb and
returning early to prevent further processing with invalid data. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/mediatek: fix potential OF node use-after-free
The for_each_child_of_node() helper drops the reference it takes to each
node as it iterates over children and an explicit of_node_put() is only
needed when exiting the loop early.
Drop the recently introduced bogus additional reference count decrement
at each iteration that could potentially lead to a use-after-free. |
| In the Linux kernel, the following vulnerability has been resolved:
hsr: hold rcu and dev lock for hsr_get_port_ndev
hsr_get_port_ndev calls hsr_for_each_port, which need to hold rcu lock.
On the other hand, before return the port device, we need to hold the
device reference to avoid UaF in the caller function. |
| In the Linux kernel, the following vulnerability has been resolved:
dmaengine: ti: edma: Fix memory allocation size for queue_priority_map
Fix a critical memory allocation bug in edma_setup_from_hw() where
queue_priority_map was allocated with insufficient memory. The code
declared queue_priority_map as s8 (*)[2] (pointer to array of 2 s8),
but allocated memory using sizeof(s8) instead of the correct size.
This caused out-of-bounds memory writes when accessing:
queue_priority_map[i][0] = i;
queue_priority_map[i][1] = i;
The bug manifested as kernel crashes with "Oops - undefined instruction"
on ARM platforms (BeagleBoard-X15) during EDMA driver probe, as the
memory corruption triggered kernel hardening features on Clang.
Change the allocation to use sizeof(*queue_priority_map) which
automatically gets the correct size for the 2D array structure. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: fix use-after-free in cmp_bss()
Following bss_free() quirk introduced in commit 776b3580178f
("cfg80211: track hidden SSID networks properly"), adjust
cfg80211_update_known_bss() to free the last beacon frame
elements only if they're not shared via the corresponding
'hidden_beacon_bss' pointer. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: sme: cap SSID length in __cfg80211_connect_result()
If the ssid->datalen is more than IEEE80211_MAX_SSID_LEN (32) it would
lead to memory corruption so add some bounds checking. |
| In the Linux kernel, the following vulnerability has been resolved:
ax25: properly unshare skbs in ax25_kiss_rcv()
Bernard Pidoux reported a regression apparently caused by commit
c353e8983e0d ("net: introduce per netns packet chains").
skb->dev becomes NULL and we crash in __netif_receive_skb_core().
Before above commit, different kind of bugs or corruptions could happen
without a major crash.
But the root cause is that ax25_kiss_rcv() can queue/mangle input skb
without checking if this skb is shared or not.
Many thanks to Bernard Pidoux for his help, diagnosis and tests.
We had a similar issue years ago fixed with commit 7aaed57c5c28
("phonet: properly unshare skbs in phonet_rcv()"). |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: lpfc: Fix buffer free/clear order in deferred receive path
Fix a use-after-free window by correcting the buffer release sequence in
the deferred receive path. The code freed the RQ buffer first and only
then cleared the context pointer under the lock. Concurrent paths (e.g.,
ABTS and the repost path) also inspect and release the same pointer under
the lock, so the old order could lead to double-free/UAF.
Note that the repost path already uses the correct pattern: detach the
pointer under the lock, then free it after dropping the lock. The
deferred path should do the same. |
| In the Linux kernel, the following vulnerability has been resolved:
batman-adv: fix OOB read/write in network-coding decode
batadv_nc_skb_decode_packet() trusts coded_len and checks only against
skb->len. XOR starts at sizeof(struct batadv_unicast_packet), reducing
payload headroom, and the source skb length is not verified, allowing an
out-of-bounds read and a small out-of-bounds write.
Validate that coded_len fits within the payload area of both destination
and source sk_buffs before XORing. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix race with concurrent opens in rename(2)
Besides sending the rename request to the server, the rename process
also involves closing any deferred close, waiting for outstanding I/O
to complete as well as marking all existing open handles as deleted to
prevent them from deferring closes, which increases the race window
for potential concurrent opens on the target file.
Fix this by unhashing the dentry in advance to prevent any concurrent
opens on the target. |
| In the Linux kernel, the following vulnerability has been resolved:
RISC-V: KVM: fix stack overrun when loading vlenb
The userspace load can put up to 2048 bits into an xlen bit stack
buffer. We want only xlen bits, so check the size beforehand. |
